Ron,
The good news is you have a set of close ratio gears in your gearbox. You need
a GT6 driven plate (or Volvo 140) Borg and Beck part # HB1515 or Unipart GCP140.
Alan T
-----Original Message-----
>From: Ron Jones <earthron@yahoo.com>
>Sent: Feb 1, 2007 2:54 PM
>To: fot@autox.team.net
>Subject: [Fot] Clutch Plate
>
>A few months ago I bought a TR4 race car and have run into a problem. The
>spline's on the input shaft on the transmission are 1" in diameter. The the
>clutch plates I have for stock TR2,3,4, and 6 all fit a 1.25 diameter shaft.
>The transmission case is stamped CC 80444 and there are additional numbers of
>11 RR 77 and either DB D7 or D3 D7 stamped below the CC#. Any idea what I
>have and where I find a Clutch Plate for it?
>
> Ron Jones
>
> '58 TR3A Disassembled - Last raced 1972
> '63 TR4 Race Car
>
>
>---------------------------------
>Looking for earth-friendly autos?
> Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center.
>_______________________________________________
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|