Would rise torgue a little.
Better coming out of the corner.
----- Original Message -----
From: "Tony Drews" <tony@tonydrews.com>
To: <fot@autox.team.net>
Sent: Saturday, December 23, 2006 10:14 PM
Subject: Re: [Fot] SCCA Archives (now bore size)
> If my calculations are correct, based in 1.2 HP per cu in, 89 MM
> would make 6.7 HP more than 87 MM. 92 MM would make 17.3 HP more than 87
MM.
>
> I'm not sure I could feel 6 HP. I could probably feel 17,
> though. I'm still going to run the 87's...
>
> - Tony
>
> At 01:49 PM 12/23/2006, Kas Kastner wrote:
> >Easy to calculate how much more power from the big oversize's. Figure
about
> >1.2 horsepower for each cubic inch increase. Not nuts on accurate, but
close
> >enough for holiday gripping.
> >
> >Never Be beaten by Equipment
> >Kas Kastner
> _______________________________________________
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|