John,
What I would do is make my own out of mild steel tubing and take it to my
local plating shop to have it chromed. I don't know what state you are in
but environmental standards have forced many good shops to close. Here in
AZ, though we still have some good ones.
Joe C.
-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of jcjcarrera@comcast.net
Sent: Monday, December 18, 2006 6:35 PM
To: fot@autox.team.net
Subject: [Fot] TR4/4A badge bars
I've tried all the usual sources for badge bars for the front of my street
TR4's, Moss, RF, Victoria Brit, etc. No luck, only TR3's. Anyone on the list
know of a source? Please contact me off list at jcjcarrera@comcast.net
Enjoyed hearing everyone's comments on slot cars. My GPA would have been
much higher in college except for this addiction. Still have my two cars,
Jim Hall's Chapparel and a custom job--"Guy Farley's" stock car converted to
road course setup. Had an electrical engineering student re-wind the motor
for me in exchange for letting him use my TR3 for a date. One fast car, had
to wire two "D" cell batteries in line to beef up the braking. Burned
through my controller in a hurry, but did place in a 24 hour enduro at the
track in Williamsport, PA 1965!!
Thanks, John James
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|