At 07:23 AM 10/11/2006, Jack W. Drews wrote:
>I have a couple of rear axles to do this winter.
>
>When the number of shims under the pinion head bearing race must be
>changed, that race must be put in and out maybe more than once.
>
>Does anybody have a good idea for a bearing puller that will pull that
>race without destroying the shims, or do I just need to buy a lot of shims?
>
>uncle jack
Uncle Jack, I used an Aluminum block just a scosh narrower than the notch
in the housing. It successfully drove out (ISTR) 0.005 thick shims with no
damage. I'll be glad to loan it to you for the duration.
Jim
--
Jim Hassall
Blacksburg VA
jhassall@blacksburg.net
'63 TR4 in autox preparation - 90% finished, 90% to go
|