A couple years ago, Lincoln had a special offer for SCCA members that I took
advantage of. With the promotion I think it was about $400. The little
unit is great for sheet metal and stuff up to about 3/8" thick but when you
get into the really heavy stuff, it leaves a lot to be desired.
Joe C.
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On Behalf
Of N197TR4@cs.com
Sent: Tuesday, September 26, 2006 5:22 PM
To: fot@autox.team.net
Subject: [FOT] 110 MIG Welder
help! I am going to go shopping for an inexpensive 110 volt MiG welder for
use on square tubing and light sheet metal.
I dont want the cheapest, but the best bang for the buck.
Clarke? I see some in the $300-400 price range on eBay, but have looked at
nothing else.
Hobart & Miller seem to run at $500 plus...not sure I need to go that high.
Thanks!
Joe (A)
|