You don't need much, tension the press on the case and give it a short
stroke, then try to get the carrier out. A piece of line wrapped around the
carrier is helpful, as is a dull prybar. I've put a fair amount of pressure
on the case in cases where the fit was very snug, but usually all you need
is a little pressure to ease the preload.
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On Behalf
Of alfetta95@optonline.net
Sent: Friday, August 18, 2006 7:24 AM
To: FOT@autox.team.net
Subject: [FOT] Another rear diff question
List,
Thanks for the response on the removal of the carrier. I'll be using a
press to remove it. The question is how much movement is required to release
the carrier from the case? I don't want to crack the housing.
Thanks
Todd Redmond
TR3A
|