Chuck,
We'll have to get the terminology correct first.
If you mean the connecting fod between the linkage arm and the
throttle shaft arm, then it is 5mm x 0.8mm. Remember, it is a
LH thread on one end, and a RH on the other. My connecting rod
is 60mm long with 15mm thread on each end. The top of the
rod end should be lower than the top of the valve cover (I have a
TR6).
Shane Ingate, wiring the dash, in Maryland.
Chuck Arnold asked:
>does anyone know the thread diameter and pitch of the linkage arms used on
>the Cannon thrple DCOE setup -- I need to get shorter arms as the front one
>is too tall to fit under the hood on the TR250. Or is the problem really
>my
>74 TR6 engine is not fitting in the engine bay properly?
|