Jack's got it. And, that's the name of that tune.
Never Be beaten by Equipment
Kas Kastner
----- Original Message -----
From: Jack W. Drews
To: Tim Murphy ; fot@autox.team.net
Sent: Monday, July 10, 2006 10:06 AM
Subject: Re: [FOT] TR-4 pushrods
I don't know if anyone else has contributed their wisdom on pushrod
length, but here is my understanding of it.
Theoretically, at half lift, the valve tip, the center line of the
rocker shaft, and the pushrod end should be in a straight line.
So looking at the rocker position, one end at a time............
The alignment of the valve stem and the rocker shaft are determined
by the valve stem length, the depth of machining for the valve seat,
and the height of the rocker stands. The alignment is achieved by
making the rocker stands taller or shorter. (Note -- with roller
rockers, it is proper to have the centerline of the roller horizontal
to the rocker shaft centerline, rather than having the contact line
of the roller in line with it).
At the pushrod end of the rocker, this means that the centerline of
the ball should be aligned with the centerline of the rocker shaft.
Pushrod length has no effect on alignment on the valve side of the
rocker. The length of the pushrod depends on how much has been taken
off the head and how much has been taken off the cam base circle by
the regrinding. To make it theoretically correct, you must assemble
the engine, position the valve halfway down, and measure the length
required for the pushrod. This is done with an adjustable pushrod. At
the valve end, the spring is replaced by a very light one to make the
operation easy.
In real life, some builders go to all this trouble to measure the
pushrod length, but many do not. Many just look at whether or not the
adjusting screw is reasonably centered in the rocker, so that there
is enough for the adjusting nut on the top and no interference of the
pushrod on the bottom. Interestingly, it is often the case that about
the same amount is milled off the head and is ground off the camshaft
base circle, in which case, a stock length pushrod is just fine.
At 10:26 AM 7/8/2006, you wrote:
>Question on pushrods. etc........................................
>
>
>=== Help keep Team.Net on the air
>=== http://www.team.net/donate.html
uncle jack
------------------------------------------------
No Virus Found In This Message
Scanned at barracuda.geneseo.net
=== Help keep Team.Net on the air
=== http://www.team.net/donate.html
|