good advice--that's about right. .002 isn't bad either if you have a good
oil pump
-----Original Message-----
From: owner-fot@autox.team.net
To: 'J.C. Hassall'; fot@autox.team.net
Sent: 5/2/2006 6:56 PM
Subject: RE: [FOT] TR6 main journal clearance?
Jim, right wrong or indifferent, the info I have is .001/.0027 clearance
on
the rod bearing and .0012/.002 on the main bearing clearances. When I
put
mine together I went for .0015 each.
Marty Sukey
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On
Behalf
Of J.C. Hassall
Sent: Tuesday, May 02, 2006 9:09 PM
To: fot@autox.team.net
Subject: [FOT] TR6 main journal clearance?
Amici,
A friend has been asked to rebuild a street TR6 engine. He needs the
main
and rod journal diameter ranges and recommended clearances but his
Haynes
manual doesn't have the data. Anyone have the info?
TIA
Jim
--
Jim Hassall
Blacksburg VA
jhassall@blacksburg.net
'63 TR4 in autox preparation - 90% finished, 90% to go
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.385 / Virus Database: 268.5.1/328 - Release Date: 5/1/2006
|