Jack,
Not being able to picture what the heck you were talking about, I googled
"crank scraper". Much to my amusement I found www.crank-scrapers.com
They like the idea of using the pan attachment bolts, something that makes
more sense to me than the main cap bolts.
This does look like a very attractive HP per $$$ investment. You peaked my
interest.
Something to think about, not all Moldex cranks are created equal. I had to
grind some material out of the webs of my block to allow room for the crank
to rotate. The counterbalance throws on my Moldex are bigger than most, I
think...
=== unsubscribe/change address requests to majordomo@autox.team.net
|