There should be a bearing house in the portland area. if the seal has
numbers on it they can match it up. or measure ID -OD. Good luck! Jeff
----- Original Message -----
From: "Bill Babcock" <BillB@bnj.com>
To: "'rob '" <19to1tr6@comcast.net>; <owner-fot@autox.team.net>; "'FOT '"
<fot@autox.team.net>
Sent: Sunday, April 17, 2005 8:03 PM
Subject: Rear end
> Thanks for all the suggestions. I pretty much faked it, and I think it
> came
> out okay. I have .006 lash, and the pinion mark looks reasonably close to
> the middle of the tooth, on both drive and overrun. I'm calling it good. I
> need a new seal though. It doesn't look like something I can get at a
> bearing shop. Wonder how fast I can get one from Moss.
>
> I didn't dare trust any of the bearings, and I didn't have any new ones,
> but
> I had a lot of used ones. They look good, I'll keep my fingers crossed.
|