| To: | fot@autox.team.net |
|---|---|
| Subject: | Re: Braided Steel lines - best method/tools for cutting? |
| From: | Richard Good <goodparts@verizon.net> |
| Date: | Fri, 04 Mar 2005 22:31:58 -0500 |
An abrasive cut-off usually works well. Tape the area first then cut through the tape. Clean the grindings out of the inside before installing fittings. Richard Good |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Braided Steel lines - best method/tools for cutting?, Tony Drews |
|---|---|
| Next by Date: | Re: Braided Steel lines - best method/tools for cutting?, WEmery7451 |
| Previous by Thread: | Re: Braided Steel lines - best method/tools for cutting?, Tony Drews |
| Next by Thread: | Re: Braided Steel lines - best method/tools for cutting?, WEmery7451 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |