All right guys, maybe someone has the knowledge to help sort this
out.
My daughter asked if I could think of a project for her 5th year
seniour eng. project at Western Mich. "OF COURSE I CAN!!" How about
a flywheel with a 5.5" Tilton clutch for the TR6?
A button clutch /flywheel with a flex plate was ruled out at
present. A flywheel with an integraded ring gear is first up.
This can be cut with a EDM mech. that dose wire cutting. I'm now
looking for some info. on the ring gear.
Known: 117 teeth
11.83" O.D.
11.475 root dia.
unknown: 1) presure angle, this is a standard at eather 14.5 or
20 degrees. Any idea which?
2) Diametral Pitch, 10 DP is very close but could be
something else. I was told that this pitch can be of some fraction.
Using these #'s in the equations it comes out close but
not the Dia. I've measured. ( -.05 dif., 11.78" OD, 11.425" R.D )
More Questions: 3) Does anyone already have the ring gear
dimensions?
4) Is the ring gear a Stub gear or a standard involute
gear?
Any help would be greatly appreciated.
David Wingett
--
CoreComm Webmail.
http://home.core.com
|