Having recently spent close to an hour getting my street/autox GT6+
up on stands, I'm looking for a jack to replace my sears floor
jack. The problem that I see with all these low-saddle jacks
is that the low section is fairly short - certainly not long enough
to reach all the way under the radiator and front rollback and
finally get to the crossmember behind. I much prefer to jack one
end at one point and get two stands underneath, rather than
having to do four corners - partially because I have a lot of
clearance in the garage and the front and back but not so
much side to side.
Am I missing something here?
(BTW, another jack that I've been considering:
http://www.pelicanparts.com/catalog/shopcart/DWKS/POR_DWKS_ACHyd1_main.htm
|