I have only seen a few in the paddocks around the Norht east region I
usualy make it a point to talk to the driver and ask the usual "how do you
like it '?everyone likes it and most talk about feeling safer and whish they
had it sooner Also they have an SCCA special for $957.00 It is a little
heavier then the $1300.00 one .In 01 you sent in your helmet they rigged it
and sent it back I don't know how it is handled now 2 week turn around in
mid season in 02 and it was 4 mths.buy wensday after Earnhardt's death
in01 rob
----- Original Message -----
From: "Bill Babcock" <BillB@bnj.com>
To: "'Peter Vucinic'" <vucinic@b140.aone.net.au>; "Gerald Van Vlack"
<jerryvv@worldnet.att.net>; "FOT" <fot@autox.team.net>; "Triumphs"
<triumphs@autox.team.net>
Sent: Monday, September 08, 2003 9:13 PM
Subject: RE: Seat Belt Anchor Bolts and HANs device
> Summit has anchor bolts. I wouldn't use the old stuff. Good, load rated
> eyebolts with closed eyes are what you want--the cast ones.
>
> Is anyone using a Hans yet? I'm thinking about it.
> -----Original Message-----
> From: Peter Vucinic [mailto:vucinic@b140.aone.net.au]
> Sent: Monday, September 08, 2003 5:37 PM
> To: Gerald Van Vlack; FOT; Triumphs
> Subject: Re: Seat Belt Anchor Bolts
>
>
> Gerald,
> If you are after a simple "eye" bolt, you might want to try a place that
> sell chains and lifting equipment etc. These "eye" bolts come in both
> imperial and metric threads and are load rated as well. May be easier to
> get than originals. I have used these myself.
>
> Kind Regards
> Peter Vucinic
> WORKS-4
> TR-4
>
> ----- Original Message -----
> From: "Gerald Van Vlack" <jerryvv@worldnet.att.net>
> To: "FOT" <fot@autox.team.net>; "Triumphs" <triumphs@autox.team.net>
> Sent: Tuesday, September 09, 2003 10:35 AM
> Subject: Seat Belt Anchor Bolts
>
>
> > Does anyone have 2 Seatbelt anchor bolts (eyebolts) for a TR4A that
> > they
> would
> > be willing to sell? Need 1 since I broke it trying to remove it and
> > may
> well
> > break the other one when I get to it later in the week. These Bolts go
> through
> > to a plate welded just inside the rear wheel opening.
> > I'd appreciate any help that I could get.
> > Thanks
> > Jerry Van Vlack
> > Hudson, OH
|