Bill,
Since they are featured on "Uncle Jacl's Racing Services"
http://www.tonydrews.com/Jack_Parts.htm , you could try him at
vinttr4@geneseo.net
Hugh Barber
Hollister, CA
'73 TR6
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net]On
Behalf Of Bill Babcock
Sent: Saturday, August 23, 2003 12:33 PM
To: 'Tony Drews'; fot@autox.team.net
Subject: RE: TR6 alloy front hubs available
I presume these also work on TR3/4 since I don't recall any difference
between tr3 and tr6 hubs. Yes?
Does anyone have an email address handy for southwick?
-----Original Message-----
From: Tony Drews [mailto:tony@tonydrews.com]
Sent: Saturday, August 23, 2003 11:36 AM
To: fot@autox.team.net
Subject: Re: TR6 alloy front hubs available
Picture of the kit is at http://www.tonydrews.com/hub_kit4.jpg . No
financial interest, but I'm happy with my set.
- Tony Drews
At 11:41 AM 8/23/2003, SHANE Ingate wrote:
>All,
>
>This just in. Southwick Machine are making a run of front alloy hubs
>for the TR6, including Timken bearings etc. If you need a set, better
>call Bob at 309-949-2868 because I think that all the hubs in their
>current run may be accounted for, but I am sure they will add more if
>asked. The current run is being made over the next 5 days, and once
>the dies are removed, they stay off until a minimum order number is
>reached; the wait between production runs is long.
>
>This is not an endorsement for Southwick Machine, as I have not had any
>experience with their products. I have ordered a pair of hubs, so I am
>about to find out first hand.
>
>If someone could cross-post this to the 6-Pack list, I think some folk
>there may find this news interesting.
>
>Shane Ingate in Maryland
>
>_________________________________________________________________
>MSN 8: Get 6 months for $9.95/month
>http://join.msn.com/?page=dept/dialup
|
