Hi John,
I adjusted the valves after doing work to unshroud the inlet valves, and
milling the head 45 thou this winter.
The problem was also there last summer after oversize inlet and exhaust valves
were installed with new guides, and the valves set where I had the head work
done. I even checked by emailing Kent Cams, because the clearance of 22 thou
inlet and 24 thou exhaust seemed very big, so I don"t think thats it. I'm
going to try measuring compression though, that may give a clue.
Simon.
Regards,
Simon Rasmussen
Sales Manager - Telephones To Go
Email: Simon@TelephonesToGo.ca
Mobile: (416) 565-0031
Tel: (416) 650-0000
Fax: (416) 650-5751
|