Bob, install the throttle discs with pop rivets, then file and fill with
bondo the shaft until smooth. You never lose the screws and you can
drill out the pop rivets if needed. Ted
BOB KRAMER wrote:
>Also just back from TWS race weekend...... I experienced a different kind of
>ailment and I wonder if this is very common: During a pre-race check, I
>found both throttle shafts broken at a plate screw-hole. One broke during an
>April event (that explains the mystery zero spark plug gap!) and the other
>must have given up this weekend. The engine swallowed and hopefully spit out
>the 2 screws. I am going to borrow a scope and check out the pistons and
>bores, but it still runs OK. Without any other easy options, I cleaned
>everything up and reinstalled the throttle plates using Superglue, based on
>a recommendation from Rick Junkermeier. I had my doubts, but it held up for
>a 20 minute and 15 minute race Sunday. Obviously I'll take it apart and
>rebuild, but interesting nonetheless.
>Bob Kramer
>rkramer3@austin.rr.com
>----- Original Message -----
>From: "Susan Kahler" <spitfiresuz@141.com>
>To: <fot@autox.team.net>
>Sent: Sunday, May 18, 2003 9:37 AM
>Subject: Cam questions
>
>
>
>
>>Good morning, all!
>>
>>In brief (we've gotta run yank an engine), Tristan's cam was found
>>yesterday to have a bad lobe and we've got to get another cam in there
>>before Mosport. We have a new Paeco cam (I can post specs later if
>>necessary -- it is something like an SF-8000) or can choose another cam.
>> I personally have heard bad things about Paeco, and I don't remember if
>>it was their cams specifically, their heads, or just their whole
>>
>>
>operation.
>
>
>>My question is this: Would you guys recommend the Paeco cam, or if not,
>>which cam would you recommend? I seem to remember the cam that was in
>>Tristan was a Crane 289, but it's been so long I don't remember if that
>>was the one out of the old race engine from when I got it or if that's
>>the one that is in there now (we'll find out in a couple hours!).
>> (Tristan is a 1967 1300cc Spitfire.)
>>
>>Thank you for the advice!
>>
>>Keep Triumphing,
>>Susan :)
>>
>>
>
>
>
--
Ted Schumacher
tedtsimx@bright.net
http://www.tsimportedautomotive.com
108 S. Jefferson St.
Pandora, Ohio, USA
Fax: 419.384.3272 (24 Hrs.)
Phone: 800.543.6648 (US & Canada)
Tech/ Gen. Information/ Worldwide: 419.384.3022
|