The letter that Ed Barnard posted previously failed to mention that these
will fit both spit and gt6. It will work on the non rotoflex gt6, and replace
the rotoflex on the others.
Ed does not want to sound like a commercial here, but he has put a lot of
work into this project trying to come up with a safer system for us at a
reasonable cost. I personally think he has done a great job. The axle he has
come up with should be a major safety improvement for all of us.
Ed Is making these available to us at his cost, so there is no financial
incentive in it for him at all, and may even order an extra set or two in case
some of us dont order right now. Personally, I would like to see as many
orders as possible, & we may even get the price down a bit more... (this
started out quite a bit higher). As it is, it's not a lot more than replacing
one destroyed axle & hub, with the associated u-joint, bearings & seals.
I'm anxious to get a little safer system under my car so I can have a little
more fun on the track.
If anyone has any questions, just contact Ed, or i can try to answer them
for you.
Hope this isnt too commercial, but there is NFI on my part (or Eds').
Thanks,
Tom
|