Bob,
Are you just trying to set the cam up? If so the valve rocking method always
works for all symmetrical cams.
John Kipping
----- Original Message -----
From: Kramer, Robert <RKramer@rdoequipment.com>
To: <fot@autox.team.net>
Sent: Thursday, April 25, 2002 4:39 AM
Subject: G-3 cam set up
> FOT
>
> I'm building a spare engine for the TR4. Looking at the Specs listed in
the
> Comp Prep Manual, it says inlet open s at 51 BTDC closes 79 ATDC. Exh.
Opens
> 79 BBDC and clsoes 51 ATDC. Duratiom 309 and total lift .499
>
> The closest we can get to this using a checking setting of 50 but it's
> inlets at 54-70 and exhaust 81-47. Obviuosly we're doing something wrong.
> Does anyone know at what point you are supposed to check a G-3 cam?
>
> The machinist thinks it may have been reworked,.
>
> Thanks,
>
> Bob Kramer
|