ask SANTA for one !!
----- Original Message -----
From: "jaboruch" <jaboruch@netzero.net>
To: "Mike Rose" <lytspeed@wcnet.org>; <fot@autox.team.net>
Sent: Thursday, November 29, 2001 9:11 PM
Subject: Re: 240Z drums
> To make mine fit, I also opened up the center hole, and wheel stud
> holes. I machined the outer edge, as well as making the space between
> the steel friction area and the outer aluminum deeper, to clear the
> lip of the backing plate. If I had a digital camera, I would send a
> picture, since that would probably make more sense, but I do not.
> Joe(B)
>
> ----- Original Message -----
> From: Mike Rose <lytspeed@wcnet.org>
> To: <fot@autox.team.net>
> Sent: Sunday, November 25, 2001 11:40 AM
> Subject: 240Z drums
>
>
> > I tried to install a set of Datsun 240Z drums on the rear of my TR3
> today and
> > had a bit of a problem. I had the center hole enlarged but it seems
> as though
> > the outer casting (the part that extends beyond the fins) comes in
> contact
> > with the backing plate and thus will not allow the drum to mount on
> the car.
> > Does anyone know if just machining the ridge of the drum off up to
> the fins
> > will work or is there other machine work that must be done to allow
> the use of
> > these drums on a TR3/TR4?
> >
> > Mike Rose
> Only $9.95 per month!
|