Hi guy's I am running a 4" wide---- 1/8 thick stainles semi circle . It
is notched around the lay shaft and extendeds about 3 " below the shaft then
follows the line of the bell housing to about 2 0clock over to the pasenger
side (Never considered a fellow racer getting hit) It is atached in 3
locations directly to the tranny I just used a long grade 8 bolt which is
lock washered & nutted then flat washered and then the shield brackets
(brackets are welded to the shield) At the very least I think I need a couple
more brackets . Any way what are the rest of you guys using ? I made
it up with 20 ga. galvy and gave it to the local shop and they duplicated it
in stainles for a buck 20 thats $120.00 they rolled the radias no problem.
rob
|