I bet the Wildwood guts will fit. I know they have a 7/8 version. I'd be
tempted to replace it with the Wildwood unless you have an originality
problem (though they are almost indistinguishable if you use the remote
reservoir versions.
-----Original Message-----
From: jaboruch [mailto:jaboruch@netzero.net]
Sent: Tuesday, September 04, 2001 2:40 PM
To: Friends of Triumph
Subject: 7/8 inch wheel cylinders
Does anyone know where I could get a rebuild kit for 7/8th inch rear
wheel cylinders. I don't know what they were used on. I did find
someone with a kit from an MG Magnet, but the dust covers did not fit
quite right. The cylindrs are Girling part numbers 304270 and 304250.
Maybe if someone has a Girling manual, you could see what they fit,
and they I can hunt for the kits that way. Joe(B)
|