Lots of traffic on the anti-roll bar diameter but no mention of the
length of the arms to the suspension points.
----- Original Message -----
From:
To: fot@autox.team.net ;N197TR4@cs.com
Sent: 1/18/01 8:25:40 AM
Subject: Re: Sway Bars: A new company
In a message dated 1/17/01 5:30:21 PM Pacific Standard Time, N197TR4@cs.com
writes:
I contacted the list, earlier, and got some
recommendations...One was
size
of the bar at about 1 inch minimum (Kas Kastner) if I remember correctly.
Hi Joe,
Once I got away from the standard store bought sway bars of the 60's, I
used
a self made bar by bending 1" bar stock and welding on rod end anchor
points
using small pieces of angle iron. The front of the bar was
anchored with two
split aluminum blocks.
The next stage was a Jack Wheeler solid steel 1" rod with spline ends, side
arms, and bearing mounts for the bar. I had to shorten it for
the TR-3, and
had the machinist reinstall the spline on one end. This bar was
an
improvement, but the side arms were too short making it necessary to run
the
bar under the car, where it was being distroyed by the asphalt.
This bar was replaced by a 1 1/4" Speedway Engineering hollow
bar. It's
specifications are:
S.
Bar TBL 1-1/4 x
48Sx1/4WL 29"
Two
ARM ALU S.BAR
1-1/4X48SP STRAIGHT (spline side arms)
I
located and drilled my
own 1/2" hole and cut off some length with
hack
saw.
Shaft
Collar 1-1/4 IN DIA.
Pillow
BLK MTG Bronze
The side arms are mounted to the center front bolt holes of the lower
control
arms with two 1/2" rod ends screwed together. I didn't pull the
John Lye
side arm bend maneuver to anchor the rod ends to the outer front control
arm
bolt hole beside the wheel. This could be an improvement.
I did this in 1996. There are probably better setups
now.
--- R. Kastner
--- kaskas@earthlink.net
--- EarthLink: It's your Internet.
|