At 03:57 PM 5/22/00 -0500, Coffey, Jack wrote:
>does anyone out there know of source for hyd.release bearing to fit tr-250 /
>tr-6.
Well, you've got a couple of sources. Cambridge Motorsports in England
sells a ready-to-bolt-in kit. It looks like a really nice kit, but it is a
bit pricey.
If you don't mind a bit of fabrication, what Chip Bond and I did was to use
a Howe release bearing (Summit Racing part number: HRE 8288). There
was a little machining required to make this work and we had to fabricate
the mounting, but it was a lot cheaper (and Cambridge Motorsports had
not come out with their kit at that time).
>I'd like to replace all those @#$%&! Triumph parts once & for all?
The annular release bearing is really nice.
Hope that helps,
John Lye
rjl6n@Virginia.edu
|