On Jun 20, 12:57pm, Chip Bond wrote:
> in a previous contact. If they do, are any of you willing to double your
> order?
I'd have a tough time justifying it myself, but if that was the only
way to get them...
> Is the cost acceptable?
Yup, its still cheaper than the alternative.
> Does anyone have comments about "through hardening" and the E-4325 alloy?
Sorry, you're out of my league here.
> If any of you would like a copy of the drawing I'm using for quotation
> request, send your fax number.
I'd like to get a copy, mostly for my own curiousity. My fax
number is 804-589-3909. Thanks.
Once again, thanks for taking on this project, Chip.
John Lye
rjl6n@virginia.EDU
http://avery.med.virginia.edu/~rjl6n/homepage.htm
|