Chris,
Are you running a factory exhaust manifold, or a header? The factory
manifolds developed cracks all over the place but can be welded. The
manifold was a particularly good design so headers were not an improvement.
You don't need anything more than a head to manifold gasket to take the
manifold off. Once off you should be able to see cracks or see the blown out
part of the gasket.
Peace,
Pat
-----Original Message-----
From: Datsun-roadsters [mailto:datsun-roadsters-bounces@autox.team.net] On
Behalf Of Chris Collett
Sent: Monday, October 27, 2014 5:36 PM
To: datsun-roadsters@autox.team.net
Subject: [Roadsters] Exhaust leak
I jave a minor exhaust leak somewhere near the cyl heaf ex. manifold are.
Not under the car at thw manifold to ex. pipe atea but higher up. Is this a
common problem? Are there any area that typically crack, or do I just need
to buy a gasket set and dig in.
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/pat@hornesystemstx.co
m
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|