You may have a point there. If so, I've been doing it wrong for ~40 years.
Gary
----- Original Message -----
From: "Brian Conroy" <briconroy@yahoo.com>
To: "Gary and Cindy Ault" <aultgc@att.net>
Cc: "peter harrison" <granvillecomputing@hotmail.com>; "datsun"
<datsun-roadsters@autox.team.net>
Sent: Friday, November 01, 2013 6:37 PM
Subject: Re: [Roadsters] braking
I believe the driver's side rear is actually the furthest point as the brake
lines run down the passenger side.
Sent from my iPad
> On Nov 1, 2013, at 3:48 PM, Gary and Cindy Ault <aultgc@att.net> wrote:
>
> When I switched to silicone fluid years ago, I drained the original fluid,
> then filled the system with alcohol and bled flushed it out in the same
> manner
> as I bleed the system. I then refilled it and repeated the process.
> Then,
> with the alcohol out of the system, I filled it with silicone fluid and
> bled
> two or three system volumes through it, buttoned it up, and it has worked
> fine
> ever since.
>
> I have always bled the M/C first, then started with the
> passenger side rear -- furthest from the M/C -- the driver's rear,
> passenger's
> front and finally driver's front.
>
>
> ________________________________
> From:
> peter harrison <granvillecomputing@hotmail.com>
> To: datsun
> <datsun-roadsters@autox.team.net>
> Sent: Friday, November 1, 2013 12:05 AM
> Subject: Re: [Roadsters] braking
>
>
> Dave.You mentioned installing DOT 5 - did
> you flush the system before adding
> (I think acetone? is the preferred
> material.As to turning the wheels with
> brakes applied, if you weighed 2200 lbs
> and were travelling at 10-15 MPH - you
> MIGHT just be able to turn them <G>
> After 5 years of little to no use - I would 1st advise adjusting the rears
> (as
> Bob suggested) (tighten til the wheel sticks and back off one flat. Re
> bleed -
> starting at driver rear then passengers, then front then cylinders and
> recheck.If still not up to snuff - then gotta tear everything down - check
> all
> seals and frankly replace the lot. Check for pitting on the cylinder
> walls of
> the calipers (some pitting on the BASE of the cylinder is not too
> critical)
> IMHO - the standard brakes are more than adequate for some quite serious
> driving - but have a tendency to fade if used hard on downhill twisties.
> FWIWPeter Harrison
> 818 448 3181
>
>
>> From: rksmith46@hotmail.com
>> To:
> datsun-roadsters@autox.team.net
>> Date: Thu, 31 Oct 2013 22:09:44 -0400
> Subject: Re: [Roadsters] braking
>>
>> hi, ck. the rear brk. shoe adjustment. a
> few quarter turns on each
>> side can
>> make a difference in pedal height and
> pressure. like others have said,
> the
>> roadster has manual brakes, and arent
> near as good as the newer cars.
>> if you can lock up the brakes on a panic
> stop,(or at least make them
>> screech a little). they are O.K. (for roadster
> brakes).
>> make sure the front calipers arent sticking, and the rears arent
> TOO
>> tight, as the pads and shoes can overheat. old frt. calipers
>> can be
> sticky, and drag some. i think i read some where that
>> dot 5 silicone fluid,
> has more compressability than reg. dot
>> 3&4 fluid. the pedal might be
> firmer if you switch to reg. fluid. best
> of
>> luck, bob smith, ohio
>>
>>
> From: dave@ranteer.com
>>> To: datsun-roadsters@autox.team.net
>>> Date: Mon,
> 7 Oct 2013 08:14:16 -0500
>>> Subject: [Roadsters] braking
>>>
>>> early 67
> roadster
>>>
>>> bought this car in 05. been working on it off and on since.
> never
> really
>> had
>>> it on the road until now. bled through with dot 5 a
> number of years
> ago.
>>>
>>> I think Ibve replaced the brake hoses, and
> recently bled the brakes
>>> profusely. still not braking like it should.
>>>
>>> jacked the front up and had the wife hold down the brakes; I canbt turn
> the
>>> wheels.
>>>
>>> any thoughts as to where I should look?
> ________________________________________
> datsun-roadsters@autox.team.net
>>>
>>> Donate:
> http://www.team.net/donate.html
>>> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>>> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/rksmith46@hotmail.com
> ________________________________________
>>
>> datsun-roadsters@autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Archive:
> http://www.team.net/archive
>> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/granvillecomputing@hot
> mail.com
> ________________________________________
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/aultgc@att.net
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/briconroy@yahoo.com
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|