Don't waste your time with rebuild kits. You will normally find the
cylinders pitted and so if you go through the trouble with putting in new
rubber, they well still leak.
If you hone the cylinders enough to get rid of the pits, then they will
still leak.
Been there tried that,
Dana
-----Original Message-----
From: Leonard Sprague <sprague@jandmcontractors.com>
To: datsun-roadsters <datsun-roadsters@autox.team.net>
Sent: Thu, Aug 15, 2013 2:40 am
Subject: [Roadsters] '69 SPL311 rear wheel cylinders
Hello,
Can anyone tell me where I can find replacementrear wheel cylinders
both sides) for my '69 SPL311 (1600roadster)?Do any of the vendors
tock these?
Also, has anyone tried using this Napa rebuild kit?
ttp://www.napaonline.com/Catalog/CatalogItemDetail.aspx/Wheel-Cylinder-Kit-R
e
ar/_/R-UBP1065_0379995539
Thank you in advance for your assistance.
Lenny Sprague
PL311-25453/VG30
On 9/28/2007 3:45 PM, Pete Peters wrote:
From the Parts Interchange page on 311s.org:
"NAPA, rear wheel cylinder rebuild kit part # UP1065 - this is for the 3/4"
wheel cylinders if yours are not in bad shape and basically only need new
rubber parts."
Not sure about rebuild kits, but whole cylinders are available from the
vendors.
On 9/28/2007 12:14 PM, Dan Zubkoff wrote:
Try Napa rebuild kit UBP-1065.
--
eonard Sprague
resident, J and M Contractors
352) 262-4788
ttp://www.JandMContractors.com/sprague.shtml
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|