I have been looking for the the U20 head thickness dimension. I had a
belt failure and warped the head now on my car. It has been trimmed
quite a bit and is not level, which means the compression ranges from
150-215 Lbs from one end of the engine to the other. FWIW the engine
runs very well with this head, but requires super fuel. I am not going
to have this head reworked because I suspect it has been already been
milled at least .030" and I don't think I want to have it heated and
twisted back into shape. Instead I am going to use the head from my
spare engine. I would like to know if it has been trimmed, and how much.
What is the original thickness of the U20 Head?
Tom
69 2000 - Mr. Hyde
Las Vegas
http://www.datusn2000.com
http://www.nowroc.org
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|