Rob,
I always thought they were a Whitworh Standard (English) thread, but the
last time this question came up, I think I was told something different.
Suffice it to say they're not SAE or metric. Since these carbs are made
under license from SU, and most of the parts are interchangeable, Moss
Motors might be able to provide the right screws. If Keith Olan is awake
out there, he'll know. Wait to see what you get back from others. And, I'd
like to know the answer if you get it directly (no copy to the List).
Gary
----- Original Message -----
From: "robert williams" <wilrobasy@hotmail.com>
To: <datsun-roadsters@autox.team.net>
Sent: Friday, July 05, 2013 9:37 AM
Subject: [Roadsters] screw thread size for hitachi carbs
> Hello List,
>
> The ground up resto is in the home straight so looking to finish up a few
> smaller items.
> Does anyone know the thread size of the following screws:
> 4 x phillips head screws that fasten the top of the float bowls on the
> hitachi
> carbs
> 4x screws for the piston pots on the carbs for an early (1966) 1600 low
> screen.
>
> I thought they may be 11/32 unf but alas they seem to be a smaller.
> The tops of my screws are burred and battered from years of abuse so
> thought I
> would replace them.
>
> regards,
>
> Rob
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/aultgc@att.net
________________________________________
datsun-roadsters@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net
|