datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] su carb problem.

To: Datsun roadster <datsun-roadsters@autox.team.net>
Subject: Re: [Roadsters] su carb problem.
From: Jim Gammon <gtpjimgammon@yahoo.com>
Date: Fri, 17 Jun 2011 07:47:09 -0700 (PDT)
I agree, Setting mixture at idle is not ideal. I set both air balance and
mixture at 2500-3000 rpm.
 
JimG NJ SRL 69 2K

From: "Keith0alan@aol.com"
<Keith0alan@aol.com>
To: rksmith46@hotmail.com;
datsun-roadsters@autox.team.net
Sent: Friday, June 17, 2011 8:40 AM
Subject:
Re: [Roadsters] su carb problem.

Hello Bob,

    It sounds like it is running
a bit lean in the mid  range. Try raising 
the engine speed to 2500 and
setting the mixture there. A  quick test would 
be to cruise at 2500 and pull
the choke out just a little. I  normally set 
the carb mixture at 2500 and let
the idle take care of it's self.  If the mid 
range is good and the idle is
rich you can set the needles out a few  
thousandths of an inch. While this
does have some effect overall it effects idle  
primarily. 

keith


In a
message dated 6/16/2011 3:42:03 P.M. Pacific Daylight Time, 
rksmith46@hotmail.com writes:

hi keith, im working on a 69 2000, that belongs
to a  friend.
it idles, ok, and pulls resonably well, from idle to 6k rpm.
the  problem is, part throttle cruising at 2.5k--3k rpm.
it sounds like the 
engine is missing a little, and the throttle 
response is kind of  flat. 
3200-3500 rpm or above, the throttle
responds  better, more like MY roadster.
fuel press. is 4-4.5 lbs.
ive ckd, and  raised the float level 2 mm.,  ckd,
cleaned points,
tried another  condenser, all no help. point dwell is pretty
steady
when reving  engine. the timing is: 15 btdc, vac.disc., raising to
about 30 deg. at  2500-2800 rpm.  total mech.adv. is 35-36 deg.
ive
synchonized  the carbs at idle, and with throttle. ive got
the mix. set where
it idles  good, hot. ive messed with su's
for many years, but im stumped on
this  one.
if you have any ideas, please call or email  me.

thanks, bob
smith, ohio  614 418 9911

p.s. i changed the cam timing, when i first  had
this
problem. it was almost 1 cam toothe retarded. i changed
the cam  forward
1 toothe, and now it is just a fraction on 
the advance side,  much closer to
being correct, than before.
the engine seemed  to  pull better in the lower
rpm range,
but i still have the part throttle  problem. 


=
________________________________________

datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/gtpjimgammon@yahoo.com
________________________________________

datsun-roadsters@autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>