It is the negative terminal on the coil which goes to the terminal on the
distributor. But, that "negative" terminal on the coil should show +12V
relative to ground.
Gary
----- Original Message -----
From: <shas1983@netzero.net>
To: <datsun-roadsters@autox.team.net>
Sent: Monday, August 16, 2010 12:30 PM
Subject: [Roadsters] Ignition voltage or polarity issues
> Anyone had experiance with voltage/polarity problems at the distributor? I
> know the negative lead from the coil is supposed to go to the distributor,
> but
> for whatever reason the car seems to run better with the polarity reversed
> at
> the coil. Is there another point where the wiring could be reversed
> causing
> this or possibly a component failure? The ignition seems to break down
> under
> load either way. I am running a new MSD coil, so I do not believe this is
> the
> problem. I am suspicious there is another problem that has not been
> addressed.
> ____________________________________________________________
> HR Certificate Online
> SHRM Approved Human resources Certificate Program. Learn More Now!
> http://thirdpartyoffers.netzero.net/TGL3241/4c6975f769946705ff4st05duc
> ________________________________________
> Datsun-roadsters@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $16.00
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/datsun-roadsters/aultgc@att.net
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|