Ted,
Wow, I hate to be wrong like that...
Like you, I'd let gravity help. Insert bolts from above, tighten nuts
from below makes sense.
- Bob
Ted Scott wrote:
> Rob Mann, and felow members, thanks.
>
> Rob thanks for the quick response, it was less than 3 minutes, and you wrong,
> the U Joint isn't bad, it was falling off. I put the car up, and crawled under
> to note one bolt was missing, so since it looks tough to get in from below, I
> attacked from above. With a finger along the edges, I found two bolts missing.
> So hardware store up the street is closed, I will get at this tommorrow. I
> assume starting the bolts from above, and tightening from underneath is the
> correct way to get at them? I have the new Datsun book, but it didn't have any
> details on tightening up those bolts.
>
> Again, thanks for the quick help.
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|