Hi
I have been lurking here a while.
It is quite easy to remove Valve spring retainer, Valve spring etc with head
on car.
I had to replace Valve guide seals and did this by the following
Remove rocker coverRotate crank to the start compression stroke (both valves
closed - piston near BDC)Remove spark plug from this cylinder (or all)Feed in
cord or rope abbout 1/4" diameter until cylinder fullRotate crank gently up to
near TDC (you won't get ther due to rope in cylinder)Tap Valve spring retainer
down to jar loose colletsI then used a lever hooked onto side of head to lever
down valve spring. Valve is heldd open by rope.Worked for me!!
I even did this on my Sunbeam Tiger which is very awkward to work on (compared
to my Datsun 2000).
Good luck!
Cheers
David
_________________________________________________________________
Shopping Trolley Mechanic If It Exists, You'll Find it on SEEK
http://clk.atdmt.com/NMN/go/157639755/direct/01/
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|