You don't really have much choice but to adjust the fender.
Unless you want to try millng down the hinges which wouldn't be a good idea.
Have you put the hood on the car to check that the fenders are aligned to
each other?
If you're adjusting the fender by only going by the upper portion just above
the door and
right below the windshield frame/pillar, you may be inadvertently
exacerbating the problem.
Look at the bolts in the door opening, and make sure you at least CENTER
the bolts within the
fender's mounting holes. It also wouldn't hurt to check that the support is
in fact straight to the body
and the fender.
2 cents
E
----- Original Message -----
From: "Steve Harvey"
Sent: Sunday, December 27, 2009 3:59 AM
Subject: [Roadsters] Fender/Door Adjustment
> Group,
>
> ...snip.... However, the
> driver's side fender and door fit is driving me nuts. The gap between the
> fender and door is to wide but I can't close the gap any closer with door
> adjustment then it is at this point. My question is, is it possible to
> loosen all of the fender fasteners and move the fender further back
> towards
> the door to close up the gap? It looks like I will need about 3/16"
> movement to get the correct spacing. I have all of the fender fasteners
> installed including the four bolts that are just inside the fender to door
> area including a rubber spacer between the three inside bolts.
>
> Thanks
>
> Steve
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|