Not sure what the ball bearing is for, but I would imagine you might be able
to find a similar sized replacement at a hardware store.
vince
--- On Sat,
12/19/09, peter harrison <granvillecomputing@hotmail.com> wrote:
> From:
peter harrison <granvillecomputing@hotmail.com>
> Subject: [Roadsters] Thanks
& Questions
> To: "datsun" <datsun-roadsters@autox.team.net>
> Date: Saturday,
December 19, 2009, 7:39 PM
> Thanks for all the input on my Maxima
> - turned
out that it is the fuel
> pressure sensor - whatever that is - anyhoo it is
eing
> fixed - though there is
> much more to do - just keeping it running
until i get the
> bucks toget
> something else - shame though - I have always
liked the
> lines of the 86/87
> maxima.
>
> Question
>
> Took the brakes
apart - didn't think to mark left/riight
> inner/outer and
> noticed that on
TWO calipers there is a small somewhat
> rusty ball bearing in
> one end
>
>
So
>
> Should ALL calipers have such a ball bearing
>
> Does it matter if
they are a bit rusty - i.e. can i just
> clean them up
>
> What size are they
>
> Where could i find replacements
>
> Thx
>
> Peter (Eliza - TOAD SAN)
>
________________________________________
> Support Team.Net
http://www.team.net/donate.html
>
> You are subscribed as
vstrazzabosco@yahoo.com
>
> Datsun-roadsters mailing list
>
>
http://www.team.net/archive
>
>
http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|