Peeter,
As to polishing, I did my stainless with Mother's. Worked great with the
right wheel from Eastwood. Also used it on the aluminum door sill trim.
Gary
----- Original Message -----
From: "peter harrison" <granvillecomputing@hotmail.com>
To: <dato1500@hotmail.com>; "datsun" <datsun-roadsters@autox.team.net>
Sent: Thursday, November 19, 2009 10:48 PM
Subject: Re: [Roadsters] Windscreen help.
> Peter
>
>
>
> Dean is right - the instructions work great if followed - that said it is
> a
> pain. Kevin D and I (well mostly Kevin) put mine in earlier this year.
>
>
>
> The trick is a) to get all the molding in - requires a lot of soapy water
> and
> careful sliding of the moulding into the rubber grooves, and then the
> tricky
> bit is to get the 'back' of the moulding over the 'lip' of the windshield.
>
>
>
> We found that the waxy string (it seems to have no rough edges that might
> tear
> the rubber) that Home Depot offers for free to tie stuff to your car
> worked
> beautifuuly. Wrap it around (inside the inner groove) with plenty to spare
> so
> that you have two or so feet overlap at each end (they cross over) and
> then
> gently pull the rubber over onto the lip. The hardest part was lining up
> the
> moulding the 'insertion' was easy. And Dean's rubber correctly gives you
> the
> 'sharp' corners as opposed to the rounded ones. It seems to be better as a
> two
> person job (one to pull the string, the other to push (gently) the
> windshield,
> though others may have done it solo.
>
>
>
> When I decided to remove mine for painting, I found that the PO's
> 'experts'
> had used so much rubber 'glue' that you could have made a spare tire from
> it
> (thus I had to trash it, to Dean's gain <G>) . Correctly installed, it can
> be
> removed and replaced with the same effort as before.
>
>
>
> BTW - since you may have to do it again, you might as well spend some time
> doing some serious polishing of the moulding - stainless comes up
> beautifully
> when polished with fine grits (2000+).
>
>
>
> HTH
>
>
>
> Peter (eliza - toad san)
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as aultgc@att.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|