I had my 2000 running last weekend for the first time in 9-10 years. I need to
do more adjusting of the carb. but it was running. After it ran for a few
minutes I noticed it was leaking water. I thought I had not tightened a hose
enough but on closer inspection, the center freeze plug on the intake manifold
is broken on one edge. I pulled the manifold today and need to know. Can I
remove the old one and replace it myself? I see that DatsunParts.com has a set
of brass freeze plugs. Does anyone know if this set will have the one I need?
Should I replace the others? Is there anything I need to know before I try to
take the old one out? It Seems to me that if I can get the old one out I should
be able to drive a new one in by just putting a socket or something that fit
tight in the plug and drive it in.
Is there anything else I should do or check on while I have the manifold off?
When I was taking the carb off I broke one the small plastic pieces on the
throttle shaft connecting rod. I have looked on several web sites and have not
seen one anywhere. Anyone have one they would like to sell me. Or know where I
may be able to get one.
Thanks
Dan
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|