Dave,
These are pretty special bolts -- they have a small-diameter head which
requires a 10mm hex drive. (I bought mine from Snap-On.) The spacing looks
to be too tight for a conventional hex-head bolt. And, since the U20 has a
12-bolt main, I presume they're high-strength. I'd check with Nissan first,
then with the usual suppliers.
Gary
----- Original Message -----
From: "dave" <daveandlindab@comcast.net>
To: " Datsun-Roadsters@Autox. Team. Net" <datsun-roadsters@autox.team.net>
Sent: Tuesday, June 02, 2009 9:02 PM
Subject: [Roadsters] Flywheel bolts needed for a U20
>I just realized I have an engine and a flywheel, but no bolts. Defiantly
> NOT a part to play around with. Does anyone have a source or the specs
> for
> these?
>
>
>
> Thanks
>
> Dave Brisco
>
> ECR
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as aultgc@att.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|