I had the same problem with my swap. It wound up being a bad master cylinder.
I swapped it out and had no further problems. Also make sure your rotors
aren't rubbing on the caliper. I had my rotors diameter trimmed down but stil
had some rubbing on the caliper. Took a die grinder to the caliper and
smoothed the rubbing area a bit to free it up. Hope this helps.
Gary Tew
Phoenix, AZ
67 1600 w/VG30 swap
www.members.cox.net/garytew
---- Francis Anand <francis67datsun@yahoo.com> wrote:
> Hey guys i need help . I did a volvo brake conversion on 70 roadster.I used
> 311 site for info. Used original new brake master cylinder .Now the problem is
> the brake is hanging on me.
> Both the front wheels gets hot and locks doesnt turn. We took all air
> bubble out . I bled rear rt first rear left front rt front lt.. The
> front caliper i did top inside , bottom inside ,and then outside. Also
> tried doing reverse method left front right front left rear right
> rear . Is there something that i am doing wrong?
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as garytew@cox.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|