>Gordon said:
>0.565" on the tensioner shaft.
>A 9/16" washer has an ID of 0.5625", so probably a little too small.
The nominal ID of a 9/16 washer is 0.594 which gives you about 0.015"
clearance which should be about right. Gordon's right you will need to grind
a flat on one side to fit. I like idea of using Nylon or Delrin; but the
long term service temperature of these materials is fairly low (~200F) so
I'm not sure how they would do in hot oil. Maybe a cut down brass washer?
Todd Osborn (DATSFUN)
San Jose, CA
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|