Sreve,
Which fitting are you using? If you could post a pic somewhere that would be
good to see.
thanks,
Linda
-----Original Message-----
From: Steve Harvey <stebharvey@ameritech.net>
To: datsun-roadsters@autox.team.net
Sent: Tue, 30 Sep 2008 3:41 am
Subject: [Roadsters] Temp Sensor
Group,
Thanks for the replies. There's only one threaded fitting on the front of
the intake manifold so I plan on installing a "T" which will allow me to
install the temp. sensor and leave the current piping that runs to the
manifold. This should solve the problem. Now to figure out where to install
the temp gauge in the dash area so it looks good but won't cause a trip to
the clinic for stitches.
Steve
You are subscribed as ljordan704@netscape.net
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|