So this past weekend I go under the valve cover to replace a rocker arm stud
that I had been replaced with a bolt one race weekend. Lo and behold, I find
the rocker arm oil restriction screw just laying around waiting to go down
some small hole. Yikes.
I think it's been discussed here before, but I cannot find the thread. Cannot
find any mention of it in the manual either.
1) How is it adjusted? I started at 2 turns out from bottom.
2) Should it have a lock nut on it? (I put one on) and thus should I be
looking for one floating around too? I have looked, but did not see any
additional parts (including the addtional rocker arm tower stud that was
missing a nut, though I found a washer.)
arfgggghh.
Thanks for any help.
Steve Steve's Racing web site
www.NoNameRacing.com
Elkhart Lake Racing & Sipping Society home
www.elrss.com
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|