I was thinking that they were fairly close in thickness. One was like 1/8" and
the other like 1/4". Does anyone have the actual specifications for the
thickness of each plate? Someone said .8" but that seems way too thick. That
would be 100 pounds of steel.
Andy
----- Original Message -----
From: "Guy" <sales@foilgraphics.com>
To: "dave" <daveandlindab@comcast.net>, "Dewey Hahlbohm"
<hahlbohmd@earthlink.net>, "Datsun List" <datsun-roadsters@autox.team.net>
Sent: Thursday, March 20, 2008 5:56:14 PM (GMT-0600) America/Chicago
Subject: Re: [Roadsters] Bell housing front cover question
Dave,
Thank you for the suggestion on the transmission mount. Great suggestion.
I will use it.
Guy
67.5
Chandler, AZ
----- Original Message -----
From: "dave" <daveandlindab@comcast.net>
To: "'Dewey Hahlbohm'" <hahlbohmd@earthlink.net>; "'Datsun List'"
<datsun-roadsters@autox.team.net>
Sent: Thursday, March 20, 2008 11:35 AM
Subject: Re: [Roadsters] Bell housing front cover question
> Everyone pretty much covered the plate, need the thin one. Don't forget
> to get the cheap Chevy trans mount, ~$25.00, 10 minutes of work, will
> never break.
> http://www.311s.org/pmwiki-311/pmwiki.php?n=TechSection.ChevyTrannyMount
>
> Good thing, you can sell off the 5 speed as a kit, make big $$
>
> I have an extra 4 speed crossmember and driveshaft I was going to put on
> Ebay. If you need, just email.
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|