I have had luck with Wolf Steel for custom patch panels. If you send him your
rusted out original piece he will fabricate a new patch panel and does a good
job. Depending on the size and complexity of the part his price is fairly
reasonable. Located in CT.
http://www.alfaparts.net/
Andy Conner
SRL 311-01633
-------------- Original message --------------
From: davesmbox@aol.com
> Hey List,
> I tried Craig and the ushual suspects with no luck.
>
> My 69 1600 has been patched twice over the last 12 years on the passenger
>side
> rear wheel arch just past the axle center line down to the rear about 12
>inches.
> It's bubbleing through again so it's time to cut the section out and weld in
>a
> better patch.
> Any one with a parts car with a non rusted section. Time is money so I know I
> will need not only to pay for the part but your time to cut it out.
> Email me off list if you can help out.
>
> Thanks,
> DAVE
> ________________________________________________________________________
> More new features than ever. Check out the new AOL Mail ! -
> http://webmail.aol.com
> ________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as conner_a@comcast.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|