A while back I purchased studs and nuts from Dean. Part numbers 1545 and
1842, respectively. These were put on my '70 SRL with 15" Panasports. They
fit perfectly.
Matt
-----Original Message-----
From: datsun-roadsters-bounces+matthews517=earthlink.net@autox.team.net
[mailto:datsun-roadsters-bounces+matthews517=earthlink.net@autox.team.net]
On Behalf Of Mike H.
Sent: Saturday, January 26, 2008 11:33 PM
To: Datsun Roadster List
Subject: [Roadsters] Studs too short for new Panasports
Well I finally got a set of new 15" Panasports for the '67 stroker. There's
one issue, actually it's a problem.
The wheel studs seem too short. The tapered nuts that came with them will
only go 6 full turns from barely on to full tight. 4 turns on a couple other
studs. At 20 threads (meaning turns) per inch for 7/16 - 20 studs, this
means
less than 1/4" to less than 3/8" of bite. I'm sure that's not enough to be
safe. After measuring wheel flange thickness and nut thread lengths, I'm
thinking I need at least 1/2" to 3/4" longer studs but not long enough to
bottom out on the nuts. I have checked the forum and list archives, looking
for a specific replacement, length, brand, or source. When I broke a stud a
few years ago, I bought some of the Corvair studs mentioned on the
interchange
list. They would have probably worked but I thought the knurling looked
rather
knarley so I just got some from Nissan. And they were the stock ones.... too
short.
Anyone else experience this problem with stock studs and Panasports? Any
help?
Mike Hudson '67 - 1600
You are subscribed as matthews517@earthlink.net
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|