Peter,
What part of Oregon are you in?
I have the front section of a frame I need to strip some parts off of. I
would have to look but I bet what you need is there. You are welcome to the
frame section if it will give you what you want. Get back to me and lets
see if/when we can get together.
Tom
69 2000 - Mr. Hyde
Portland
http://www.datsun2000.com
http://www.nowroc.org
-----Original Message-----
From: datsun-roadsters-bounces+tom=datsun2000.com@autox.team.net
[mailto:datsun-roadsters-bounces+tom=datsun2000.com@autox.team.net]On
Behalf Of Pete Kandratieff
Sent: Tuesday, December 04, 2007 11:44 AM
To: datsun-roadsters@autox.team.net
Subject: [Roadsters] Front sway bar pillars
Hello, All.
My '69 2000 's in need of both, drivers and passenger side, front sway
bar pillars.
I recently learned it was hit on the front drivers
side corner, low enough to take out the drivers side pillar,
which was poorly welded/aligned back onto the frame by PO,
and bent the pass. side pillar.
Ideally, the replacement pillars should be cut out of the donor
frame with pillar welds still intact for sake of better transfer
to my frame, right? Can someone help?
I'm not a welder so any suggestions would be great.
Thank you.
Peter
Oregon
________________________________________
________________________________________
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|