Gary,
5/16 x 24 TPI Shaft length was 1.18 inch with engaged thread area being
.93 inch of that.
I have these bolts in a bag with the big washers marked re-use because I was
not able to find exact replacements yet.
Jim
----- Original Message -----
From: "Gary Tew" <garytew@cox.net>
To: "datsun list datsun" <datsun-roadsters@autox.team.net>
Sent: Thursday, October 04, 2007 6:21 PM
Subject: [Roadsters] windshield installation
> Anyone know the bolt size for the 4 bolts that secure the windshield to
> the body along the sides? Update.. I installed the dash this week
> along with a new dash cap from Dean. Fit and finish look great but I
> didn't have those pointy screws for the dash cap install. Man, do I
> wish I had them. I highly encourage you to keep your old ones if
> possible or buy new ones. I used some junky ones to initially do about
> every other hole. Then, I used my new ordinary screws to fill in the
> remainder of the attachments and then replaced the old pointies with new
> hardware. I'll have some pics on my site soon. Most of my wiring is
> done. I'll be doing the center radio console after I get the windshield
> installed. Cheers.
>
> Gary Tew
> Phoenix, AZ
> www.members.cox.net/garytew
________________________________________
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|