--===============1055237485==
Content-Type: text/plain; charset="windows-1250"
Content-Transfer-Encoding: 7bit
Lower BJ has the following dims: -
large diam. = 17mm[0.669"]
small diam. = 15mm[0.590"]
taper length = ~19mm[~0.75"]
: )
-----Original Message-----
From: datsun-roadsters-bounces+graemes=internode.on.net@autox.team.net
[mailto:datsun-roadsters-bounces+graemes=internode.on.net@autox.team.net] On
Behalf Of Andy Cost
Sent: Wednesday, 3 October 2007 7:24 AM
To: datsun-roadsters@autox.team.net
Subject: [Roadsters] Ball joint taper
Does anyone have information about the lower ball joint shaft taper? How
about a dimensioned drawing? I'm working on the race car and need some
information before going custom.
Andy
________________________________________
graemes@internode.on.net
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
No virus found in this incoming message.
Version: 7.5.488 / Virus Database: 269.13.37/1042 - Release Date: 1/10/2007
6:59 PM
Version: 7.5.488 / Virus Database: 269.13.37/1042 - Release Date: 1/10/2007
6:59 PM
--===============1055237485==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
________________________________________
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
--===============1055237485==--
|